toworkfor

Heat resistant sole up to 300˚C 100% non metallic Water impermeability Resistance to water absorption THINSULATE Cold Insulating 3D BONDING Injection technology Q-FLEX Perforation resistant STEEL Perforation resistant CARBONLIGHT Toecap impact resistant up to 200 Joules ALUMINIUM Toecap impact resistant up to 200 Joules STEEL Toecap impact resistant up to 200 Joules CLASS 2 Chainsaw protection C A S SYMBOL REQUIREMENTS/CHARACTERISTICS NECESSARY PERFORMANCE P E A C EN 50321 WRU CI HI HRO FO WR M AN CR Penetration resistance sole Heel energy absorption Antistatic footwear Conductive footwear Electrically insulating footwear Water penetration resistant uppers Insulation against cold Insulation against heat Resistance to hot contact of the outsole Resistance to fuel oil of the outsole Water Resistance Metatarsal protection (only for EN ISO 20345) Ankle protection Cut resistance of the upper ≥1100 N ≥ 20 J Between 0,1 and 1000 M Ω < 0,1 M Ω Class 0 or 00 ≥ 60 min. Test at -17°C Test at 150°C Test at 300°C ≤ 12% ≤ 3 cm² ≤ 40 mm (Size 41/42) ≤ 10 kN ≥ 2,5 (índex) SYMBOL SLIP RESISTANCE NECESSARY PERFORMANCE SRA SRB SRC Ceramic + Sodium lauryl sulfate Steel + glycerin SRA + SRB Heel ≥ 0.28 / flat ≥ 0.32 Heel ≥ 0.13 / flat ≥ 0.18 ESD Electrostatic discharge (EN 61340-2-1) Between 0,1 and 100 M Ω EN ISO 20344:2011 - Test methods for footwear designed as Personal Protective Equipment. EN ISO 20345:2011 - Specifications for safety footwear for general use: footwear with specific characteristics to protect the user against injuries that might occur in the work place. Fit out with a toecap, this footwear protects the user against crushing impacts with a protection provided on 200 Joules. EN ISO 20347:2012 - Specifications for safety footwear: footwear with specific characteristics to protect the user against injuries that might occur in the work place. (This footwear is not equipped with toecap for feet protection). ASTM F2413-18 - Shoes and boots tested and approved at a voltage of 18000 V at 60Hz for one minute. CATEGORY CLASS SB Closed heel area | Antistatic properties | Heel energy absorption | Resistance to fuel oil | Resistance to oils REQUIREMENTS I S1 S2 I Like S1 integrated by water penetration and absorption S3 I Like S2 integrated by perforation resistant | Cleated outsole S1P Shoe with basic requirements - footwear with toecap - resistant to 200 Joules Like S1 integrated by perforation resistant I O1 I Closed heel area | Antistatic properties | Heel energy absorption O2 I SYMBOLS A A/E/FO/P A/E/FO WRU A/E/FO/ WRU/P A A/E/WRU E FO E MATERIALS AND PRODUCTION: All the materials used, either natural or synthetic, and also the applied production techniques were chosen to comply with the requirements of the above european standard in what concerns safety, ergonomics and comfort. Besides the required basic characteristics, the footwear may have additional characteristics indicated by the symbols or categories in the labels inside the footwear. Like 01 integrated by water penetration and absorption 2 ESD ElectroStatic Discharge AIR TUBLESS Anti-fatigue tubular sole TENCEL Wood cellulose material SYMPATEX Waterproof membrane HYDRATEC Waterproof membrane EH Electrical Hazard Protection Nitrile Rubber sole